Looking for MODE80.COM file?

Expert (68)

27-05-2011, 12:49

In the msxblue page manual when talks about SVI-727 extenxion mention a program named MODE80.COM to change 80 column mode.
Does anybody knows where can I find it?

Best regards,

Guseco

Для того, чтобы оставить комментарий, необходимо регистрация или !login

By o.geerdink

Hero (588)

10-05-2015, 10:39

By gdx

Enlighted (6115)

10-05-2015, 11:17

On site below in the SVI-738's ressources archive (SVI-738.zip), WIDTH80.COM (not MODE80.COM) can be found into the 738msxdos.dsk.

http://www.vik.cc/bluemsx/resource.html

By o.geerdink

Hero (588)

10-05-2015, 11:57

tnx

By o.geerdink

Hero (588)

12-09-2017, 12:10

That file is for the v9938 in the 738, i need mode80.com for the svi 727!

By NYYRIKKI

Enlighted (6033)

12-09-2017, 13:45

I know I have it somewhere, please hold on...

By NYYRIKKI

Enlighted (6033)

12-09-2017, 13:53

Found it... mail sent.

By gdx

Enlighted (6115)

13-09-2017, 02:04

I would be curious to see what this command does exactly. WITH80.COM did not work?

By NYYRIKKI

Enlighted (6033)

13-09-2017, 07:09

gdx wrote:

I would be curious to see what this command does exactly. WITH80.COM did not work?

It is pretty boring stuff... It sets up raster address registers, sync positions etc to CRT controller, adjusts LINLEN and populates the standard hooks... No much to see...

Ps There is also pretty similar program called PUT9000 for V9990... though that one also adds VT100 support.

By o.geerdink

Hero (588)

13-09-2017, 09:36

Thanks NYYRIKKI I want to control the vdp chip in the svi 727 cartridge and see if I can use it fully.

By Manuel

Ascended (19310)

13-09-2017, 09:37

What do you want to do with it then?